How To Fix Cuckoo Clock Chains

HOW TO Go HELP

SIMPLE PROBLEMS

SERVICE STATIONS

UNPACKING A NEW
CUCKOO CLOCK

SHIPPING A
CUCKOO CLOCK

REPLACEMENT PARTS

SIMPLE Bug

Please note: Nosotros are trying to explain the solutions to a few like shooting fish in a barrel problems here. However if you should endeavour to gear up such a problem yourself, you Practice THIS AT YOUR OWN Run a risk. Yous should also note that this may VOID THE WARRANTY on your clock.

If you practise not feel comfortable working on the clock yourself, see HOW TO GET Aid.

Hither is the list of simple bug:

Later unpacking the clock the cuckoo (and the music with musical clocks) does not work A chain is off the wheel The Clock runs too slow / also fast The Clock Stops The clock does not cuckoo on the full and on the half-hour, but at other times The cuckoo calls the wrong fourth dimension (for example 5 times at 7 o'clock, half-dozen times at 8 o'clock) After the cuckoo has called, the door stays open up

Afterward unpacking the clock the cuckoo (and the music with musical clocks) does not work

Please make follow the SETUP INSTRUCTIONS carefully, when unpacking the clock. If the clock should not piece of work in the end, please check the following points: 1. Have the clamps been removed from the bellows inside the clock equally described in the instructions (see film)? 2. Has the cuckoo's door been "unlocked"? You have to turn a little wire to the side, that secured the door while aircraft (see film). 3. Please check the position of the dark shut-off. The nigh common reason why cuckoo and music do not work is that they have been turned off. With some clocks the nighttime shut-off is a switch at the left side of the clock, with other types it is a wire under the clock (see picture). CHECK both positions of the night shut off and make sure that the switch is not "somewhere between" the ON and OFF position.

A chain is off the wheel

If 1 of the weights always drops to the floor at in one case, the chain has fallen off the bicycle. Fixing this is not so easy, it will require patience. To fix this pull the other bondage fully up, remove all weights. Accept a piece of wire and secure the other chains under the clock's instance "every bit shut as possible" to the bottom of the case (meet pic). This is VERY IMPORTANT, otherwise the other chains will fall of their wheels too during the next step. Take the clock from the wall, open up it on the back. Now turn the clock upside-downward and try to balance the concatenation dorsum on the wheel.

The Clock runs too irksome / too fast

The pendulum is responsible for making the clock go along time. If your clock runs too fast, you can movement the pendulum-disc down a little on the pendulum to correct this. If the clock is running to irksome you accept to motion the pendulum-disc up. This should also be described in your clock's setup instructions. Keep in mind that moving the pendulum leaf or disc 1/8 Inch (3 mm) on the pendulum stick is equal to a 3 minute change in a 24 hour menstruum.

The Clock Stops

Delight brand sure that the clock is adjusted properly on the wall. The clock must be placed in a correct vertical position so that the pendulum tin swing freely. You must "listen" to the clock and be sure that the clock has an even Tick-Tock sound. Do non arrange the clock with your optics, do it with your ears. This is adjusted past moving the clock to the correct or left, until yous hear the tick tock sound which is fifty-fifty.

The clock does non cuckoo on the full and on the one-half-hour, but at other times

It is non the cuckoo that goes wrong, but the minute-hand is in the incorrect position. To accommodate the hand you should, loosen the hand nut, and reposition the minute-hand to the proper hour, and retighten the paw nut.

The cuckoo calls the wrong time (for example 5 times at vii o'clock, 6 times at 8 o'clock)

It is not the cuckoo that goes wrong, simply the hr-paw is in the wrong position. To set the hour hand, you can pull the hand at the attachment point on the handshaft, pulling towards the minute paw until it is loose, reposition the hand to the proper hour, and push the hand towards the dial until information technology is tight. If your clock uses wooden hands you may need a little mucilage (cyanoacrylat "super glue" ) to attach the hand once again, but delight be very careful with the glue.

After the cuckoo has called, the door stays open

If you open up the clock on the dorsum you lot will come across a thin wire that starts at the bellows and goes upward to the cuckoo. This wire should motion the cuckoo up and downward a picayune while information technology calls. It is non connected with the cuckoo but normally ends nether the cuckoo'south tail (run across motion-picture show). During shipping it may happen that this wire is turned higher up the cuckoo. If it is above, information technology may block the cuckoo and the door. To gear up this you can simply turn the wire around the cuckoo - carefully - and then it is under the cuckoo's tail again. This should be quite easy if you open the cuckoo'south door (the cuckoo will motility frontward when the door is opened).

Source: http://www.cuckooclock-repairs.com/simple.htm

Share this post